Calibration Procedure - Star Trac 3900 Owner's Manual

5. Repeat steps 2 through 4, on the right side ofthe belt/deck.
6. WALK: Start the treadmill at 1 mph and walk on all sections of the belt and deck for 1 minute
to ensure the wax has been evenly distributed and worked-in properly.
7. CLEANUP: Remove any excess wax with diluted cleaner (409) and towel, or bristle brush.
TIP: Blow away extra wax first (like dust), then wipe.
8. RESETTING THE MAINTENANCE LED: While the treadmill is on, but not running,
press the TIME display key, DISTANCE display key, and the SPEED display key
simultaneously. The MAINTENANCE LED should tum "off'.
or
TI ME SPLAYKEY

CALIBRATION PROCEDURE

Step 1: Plug in and Press Power Switch "ON". Display lights will scroll the "TRACK".
Step 2: Check to ensure the treadmill is on a flat surface. (Refer to Owner's Manual).
Step 3: Press "START" for minimum speed. Press "UP" to incline to 5% then "DOWN" to 0%.
Step 4: Press "STOP" to end. Tum Power Switch off. While depressing "DISPLAY SCROLL",
tum the Power Switch "ON".
Step 5: Do not stand on the belt. Press "START". The treadmill will automatically calibrate at
minimum, 1/2 maximum, & maximum speed for approximately 3 minutes. After treadmill
stops, press "STOP" to end.
If you are unable to perform any ofthese operations, or have any questions about this procedure,
call our customer hotline at 800-503-1221.
DISTANCE DISPLAY KEY
Manual
SPEED DISPLAY KEY
37