Change The Settings For The Screen - Panasonic CF-C1 Series Reference Manual

Digitizer / Multi Touch Operation
The following operations may not be possible depending on the application program being used.
Functions
Zoom in, zoom out
Rotate

Change the settings for the screen

Windows 7
When needed, the screen settings can be configured using the following procedure.
To Display [Pen and Touch] screen.
A
Click on the notification area and click
flicks settings].
When is not displayed:
Click (Start) - [Control Panel] - [Hardware and Sound] - [Pen and Touch],
and add the check mark in [Display flicks icon in the notification area] in
[Flicks].
Make necessary changes and click [OK].
B
CAUTION
If a change is made to the display resolution, or the cursor cannot be pointed correctly with the digitizer pen, be sure to
calibrate the screen. (
When mouse drivers are installed (e.g., IntelliMouse), the screen function may not be used.
When the operation of panning (only the internal LCD) is performed while the display resolution is set higher than the
resolution of the internal LCD, the screen function will not work properly.
Even when only an external display is in use, the cursor will move on the external display if the surface of the internal LCD is
touched when the screen driver is active. Therefore, do not touch the internal LCD when only an external display is in use.
The screen function does not work in the Setup Utility.
Windows XP
The screen function does not work in the "Full Screen" of [Command Prompt].
Use two fingers to touch the image or text you want to zoom in or out on, and draw
your fingers apart to zoom in and together to zoom out.
Use two fingers to touch the image or text, and use one finger as the center of
rotation and the other finger to rotate.
page 15)
Operation
. And then click [Customize your
14