Load (L Command); Verify (V Command); Return (R Command) - Sharp MZ-700 Basic Manual

71
3.9 LOAD (L Command)
*
L <load heading address> [<device name> : fllaname)
Loads the designated file from the designated device name. When the heading address
is specified, loading is from that address; if not specified, loading of information is
done exactly as it was saved. If filename is not specified, the first file found is loaded.
When there is BREAK or if check sum error appears, ERR? is displayed, and returns
to awaiting command; if no error appears, returns to awaiting command.
3.10 VERIFY (V Command)
*
V <fllename>
Reads designated file from cassette and compares with main memory. Used to check
whether correctly saved; if not correct, ERR? is displayed.
3.11 RETURN (R Command)
Returns monitor to called system. If from BYE command of DISK BASIC, returns to
DISK BASIC by this command. SP (stack pointer) and HL register are stored, so next
command after BYE is executed.
If SP is called from a system such as $FFOO - $FFFF, or if there is no return address in
the stack, return is not possible by this command; call that system's hot start by the G
command.