Sharp MZ-700 Basic Manual page 7

• Increase of floppy 'disk interface- ROM
• Floppy disk drive control ROM
If the DISK BASIC controls the floppy disk drive (MZ-1F02), connect the ROM chip
(see below) which is packed together with the DISK BASIC to the socket of the
floppy disk interface (MZ-IEOS: optional). If this ROM is not connected to the floppy
disk interface, the floppy disk drive cannot be controlled.
Note the following points when connecting the ROM to the interface:
• Take care not to drop, scratch or otherwise damage the ROM. Do not expose it to
a strong magnetic field.
• Take special care not to break or bend the pins of the ROM.
• Before pressing the ROM into the socket, be sure that its pins are correctly aligned
with the socket holes.
Be sure that the notches in the ROM and socket match each other before pressing
the ROM in.
Do not remove the seal attached to the ROM.
• Do not touch the pin of the ROM, because static electricity may destroy the ROM
contents.
Seal
N_-ctn