Precautions For Use - Casio V-R7000 User Manual

Precautions for Use

Read the following items thoroughly and use this product properly. CASIO bears no responsibility
whatsoever for malfunction or damage caused by handling not following below contents. Please
note that it will also result in charged repair, and actual cost required for repair will be charged,
even if it is within the warranty period.
Installation Location
Do not place in a hot or dusty location, or in any location exposed to oily smoke or water. Never
store or leave in following locations. This could erase the memory and cause a malfunction or
result in deformation of the case.
● Temperature of 0°C or lower
● Close to air conditioner
● Under direct sunlight
● Temperature of 40°C or higher
Avoid using this product in following locations.
● Outdoor
● Close to equipment that will become hot such as range, electrical heater, etc.
● Location exposed to water or steam
● Location with severe change in environment such as temperature, humidity, etc.
● Location where corrosive gas or saline matter is generated
● Location where dirt or dust is generated
● Location with vibration
● Location prone to static electricity
Dead Pixels
The LCD panel employed in this product uses high precision and substantial number of compo-
nents which commonly cause a small number of the pixels not to light or to remain lit all the time.
This is due to the characteristics of LCD panel yield in accuracy over 99.99% and permissible.
802.11a/n Restrictions
● This product is for indoor use only when using channels 36, 40, 44, 48, 52, 56, 60, or 64 (5150-
5250 MHz).
● To ensure compliance with local regulations, be sure to select the country in which the access
point is installed.
Other
● Do not turn off the power or remove the SD card while writing to or reading from the SD card.
This may result in damage to the SD card or stored data.
● Prepare separate AC power supply from the power line for motor, ice maker, microwave oven,
etc., which may generate noise.
● Do not touch the power switch with wet hands. This may result in electrical shock.
● Wipe thoroughly with dry cloth, etc., when there is any water droplet on the device.
● Do not use any volatile chemical such as thinner, benzine, cosmetics, etc., for cleaning. Wipe
with dry soft cloth when this product gets dirty. The display section may be scratched when
scuffed strongly with a cloth.
● The cover or the plastic case for the terminal may discolor or damaged when thinner, gasoline,
kerosene, various solvent, grease, any cleaner including them, adhesive, paint, medical agent,
cosmetics, etc., are adhered. Please be cautious.
E-8