Pendant Mount (Dcs-34-2) - D-Link DCS-6511 User Manual

Installation
1. Attach the mounting plate to the bracket cap using the three screws as shown in
Figure 3.1.
2. Locate a suitable position on the ceiling for a 34 mm (+2 / –0 mm) hole to be cut. A
template is included to aid in marking the mounting hole.
3. Cut the hole in the ceiling according to the template.
4. Drill 4 separate 6 mm holes corresponding to the holes in the mounting template and
insert the plastic anchors into these holes.
5. Place the rubber seal between the pendant bracket and the ceiling to ensure a
waterproof seal between the ceiling and the bracket. (Figure 3.2)
6. Attach the pendant bracket to the ceiling using the screws provided.
7. Attach the bracket cap to the bottom of the pendant bracket, rotating the cap
counter-clockwise to tighten it into place.
8. Insert the screw into the base of the pendant bracket at the top of the bracket cap to
secure the bracket cap into place.
D-Link DCS-6511 User Manual

Pendant Mount (DCS-34-2)

Mounting
Plate
Figure 3.1
Pendant
Bracket
Figure 3.2
Bracket
Cap
Rubber
Seal
Bracket
Cap
16