Fcc Information - ProForm 710E User Manual

HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, first see assembly step 16 on
page 13. Use a flat screwdriver to remove the Shield
Cover (75) and the Shield Cover Cap (118).
Next, see assembly step 15 on page 13 and remove
the Right Upper Body Leg Outer and Inner Covers (69,
83).
Then, see assembly step 12 on page 11 and remove
the Right Pedal Arm (58) from the Right Upper Body
Leg (60).
See EXPLODED DRAWING C on page 31 and
EXPLODED DRAWING A on page 29. Remove the
Right Roller Arm (59) from the right Crank Arm (20).
Then, carefully remove the Right Roller Arm assembly
from the elliptical.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
See EXPLODED DRAWING C on page 31. Remove
the M4 x 19mm Screws (5) and the M4 x 48mm Screw
(107) from the Left and Right Shields (73, 74). Then,
remove the Right Shield.
Next, locate and loosen the Idler Screw (89). Next,
tighten the Belt Adjustment Screw (91) until the Drive
Belt (113) is tight. Then, retighten the Idler Screw.
113
91
Reattach the right shield, the right roller arm, the right
pedal arm, the shield cover cap, and the shield cover.
25
89