Using Additional Footswitches And Pedals - Native Instruments Guitar Rig Kontrol Hardware Reference Manual

6.3 Using Additional Footswitches and Pedals

The RIG KONTROL features two jacks for connecting external footswitches and pedals with a
¼" patch cable. Once connected and set up, they can be assigned just like MIDI controllers in
GUITAR RIG 4 . Refer to the Getting Started Guide and the Application Reference to see how.
Under P on the o
references Ptions
►
To calibrate an external pedal, click on the Reset button next to "RIG KONTROL Ext
Pedals Calibration."
►
The two lines "RIG KONTROL Ext Pedal 1/2 Mode" allow to configure each both
inputs to match your external footswitch or pedal. Consult the manufacturer's product
specifications to find out if it is a tip or ring active pedal, or respectively, if it is an
opening or a closing switch. If problems occur, try out the other available modes.
►
The "External Switch Mode" determines the behavior of external footswitches. Either
they are "on" while pressed (Toggle) or they switch between "on" and "off" each time
they are pressed (Switch).
page of GUITAR RIG 4 , the following settings are available:
GUITAR RIG KONTROL Hardware Reference – 38