Elenco Electronics RCC-7K Assembly And Instruction Manual page 9

3
NOTE: If you
have a problem
putting the gear on
the shaft of the motor,
then gently tap the
gear on with a hard
object.
Quick Test:
Connect a
1.5V battery across the
motor wires with your
hands. The motor should
spin.
You cannot get good connections
soldering to the motor shell unless
you first file or scrape away a
small area of the outer coating.
Driving Motor
Bottom Frame
-8-
Driving Motor
(the larger motor; Yellow
wire goes to tab next to
Å marking in plastic)
Side Tab:
bend tab back
180 O and solder
to motor shell
Driving Motor
Gear
0.1mF Capacitor
(marked 104):
Solder leads to motor
tabs, one lead is also
soldered to motor
shell.
Green Wire
Yellow Wire
Interior Tab:
Å
Bend Tab 90 O ,
but don't short
to motor shell.
Å
Interior Tab
Side
Tab