Table of Contents
Advertisement
6
Quick Test: Lift the wheels off the ground so they
may spin freely. Connect a 1.5V battery across the
motor wires with your hands, (+) terminal to green
wire. The wheels should spin forward slowly but
smoothly. Reverse the wires to the battery and the
wheels should spin backwards.
Note: Try to also press down on the forward part of
the rear cover while doing this, since the forward
screws for it have not been installed yet.
Screw Used
(shown actual size)
X2
0.4" x 0.115"
0.4" x 0.115" Screws
-11-
Rear Section
Cover
NOTE: Make
sure that the wires
from the ON/OFF switch
and the motor run out of
the rear section cover
through the slots (as
shown) without being
damaged.
Advertisement
Table of Contents
Troubleshooting
