Assemble Components To The Pc Board - Elenco Electronics RCC-7K Assembly And Instruction Manual

11
ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARD
Review the soldering and parts identification instructions on p.5 at this time. In all of the following steps the
components must be installed on the top legend side of the PC board. The board is turned over to
solder the component leads.
Figure A
Figure B
Lay resistor flat against the
PC board.
Figure C
The marking on the board is
wrong for this part. Mount using
the 2 right holes, with the band
pointing towards the center hole.
This is shown here.
this hole is not used
-16-
has been pre-tuned, you do not
need to adjust it).
Align the notch on the socket (if any) with
the notch marked on the PC board. Solder
the socket to the PC board. Insert the IC
into the socket with the notch as shown.
Band
L1 - 9 Turn Inductor (this part
(see Figure A)
R13 - 1kW 5% 1/4W Res.
(brown-black-red-gold)
(see Figure B)
R14 - 1kW 5% 1/4W Res.
(brown-black-red-gold)
(see Figure B)
D2 - 3V Zener Diode
(see Figure C)
Note: "D1" (as marked on the
PC board) is not used. Place
the diode you were given (which
may be marked on your parts
card as D1) here.
IC1 - 16-pin IC Socket
IC1 - AF2311 Integrated
Circuit (see Figure D)
Figure D
Notch