Wireless Terminal Service Function - LG-Nortel GDC-345H User Manual

Aria 130c/130/300/600 DECT
Wireless Terminal (GDC-345H) User Guide

5.3.2 Wireless Terminal Service Function

These features give a user convenience to use the wireless terminal more powerfully. These
features include the functions operated by each feature button and the functions operated by User
Menu. Please refer to '5.3.3 User Menu' about operation.
Go to Pulse Function
This function is that the pressed digit signal from the wireless terminal to C.O. is generated to pulse.
Use this function in case that the outside PBX or phone(e.g. mechanical switching gear) requests
pulse tone. However, according to capability of the subscribed system, this function may be
operated or not. This function will be used for Home DECT inter-operability, not for ARIA & ARIA
series.
Press button for longer than 1 second during pre-dialing or post-dialing.
The dial tone is transferred to pulse tone.
Go to DTMF Function
This function is that the pressed digit signal from the wireless terminal to C.O. is generated to
DTMF. Use this function in case that the outside PBX or phone requests DTMF tone. However,
according to capability of the subscribed system, this function may be operated or not. This function
will be used for Home DECT inter-operability and for ARIA & ARIA series.
Press button for longer than 1 second during pre-dialing or post-dialing.
The dial tone is transferred to DTMF tone.
Vibrator/Ring Selecting Function
A user can select the one mode among Vibrator (=Ring off), Ring (=Vibrator off) and Vibr & Ring.
This function is set by Vibr/Ring setting operation in HS Setting menu of User Menu. When a
Vibrator is selected, ring tone can't be generated. But for being conscious of incoming call there is
phone vibration. When Vibr & Ring is selected, there are ring tone and vibration at the same time.
The initial state is Ring.
Silent Mode Setting Function
A user can make silent mode of the phone. Silent mode is set by pressing the OK (
more than 1 second when the phone is in idle state, then there is one time vibration. In silent mode,
there aren't beep tones, key tones and rings. But for being conscious of incoming call there is
phone vibration
To cancel the silent mode, pressing the OK(
in idle state, then confirmation tone is heard and silent mode function is disabled.
LG-Nortel systems
)button more than 1 second when the phone is
４４
) button
Issue 2.3