Table of Contents
Advertisement
viewer - The viewer user only has viewing rights (this user cannot
access the configuration menus). By default, the viewer user
has no password. This allows anyone to view the images on the
camera without being prompted for a password. If you want to
block public access to the live image, you will need to change
the password for the viewer user.
user name and then type in a new password in the password field
(retype it in the verify password field). Then click the Add/Modify
button.
Tip:
Do not forget your password. If you do, you will have to open the top
half of the camera case and press the Defaults button on the circuit
board. Some models can be set to factory defaults using a paper clip
through a small hole in the back panel.
Adding a New User
To add a user to the Users list, type in the desired username in the
Name field. Type and retype a password in the Password fields. Click
the Add/Modify button. New users will only have viewing rights; only
the admin user can make configuration changes in the camera.
Deleting a User
To remove a user from the Users list, click on the desired username
and click on the Remove button. Note: The default users, admin and
viewer, cannot be removed.
3.10 Advanced Menus
The advanced menu allows you to configure some advanced features
inside the camera such as Triggers and Dynamic DNS support.
Page 42
To modify the password of an existing user, click on the
NetCam SC MP Hybrid IP Camera
Advertisement
Table of Contents
