Securing the TV to the Wall
To Avoid the TV from Falling
1. Put the screws into the clamps and ﬁrmly fasten them onto the wall. Conﬁrm that the screws have been
ﬁrmly installed onto the wall.
You may need additional material such as an anchor depending on the type of wall.
Since the necessary clamps, screws, and string are not supplied, please purchase these
2. Remove the screws from the back center of the TV, put the screws into the clamps, and then fasten the
screws onto the TV again.
Screws may not be supplied with the product. In this case,
please purchase the screws of the following specifications.
For a 32 - 65 inches: M8
3. Connect the clamps ﬁxed onto the TV and the clamps ﬁxed onto
the wall with a strong cable and then tie the string tightly.
− Install the TV near to the wall so that it does not fall backwards.
− It is safe to connect the string so that the clamps ﬁxed on the
wall are equal to or lower than the clamps ﬁxed on the TV.
− Untie the string before moving the TV.
4. Verify all connections are properly secured. Periodically check the
connections for any sign of fatigue or failure. If you have any doubt
about the security of your connections, contact a professional
Caution: Pulling, pushing, or climbing on the TV may cause the
TV to fall. In particular, ensure your children do not hang on or
destabilize the TV. Doing so may cause the TV to tip over, causing
serious injuries or death. Follow all safety precautions provided
in the Safety Flyer included with your TV. For added stability
and safety, you can purchase and install the anti-fall device as
English - 26