Power Switch; Setting The Clock - Life Fitness 9100 Operation Manual

H P
OW TO OSITION AND
Following all safety instructions in Section 1.1, move the
treadmill to the location in which it will be used. See
Section 7, titled Specifications, for the dimensions of the
footprint. Allow a distance of eight inches, or 21 centime-
ters, between the treadmill and other units on either side.
Allow a distance of six feet, or two meters, from the rear
of the treadmill to any object or surface.
After placing the unit where it will be used, check its stability. If there is even a slight rocking
motion or the unit is not stable, determine which stabilizing leg is not resting on the floor. To
adjust, loosen the JAM NUT (A), and turn the STABILIZING LEG (B) until the rocking motion
ceases, and both stabilizing legs rest firmly on the floor. Retighten the JAM NUT.
NOTE: It is extremely important that the stabilizing leg be correctly adjusted for proper opera-
tion. An unbalanced unit may cause striding belt misalignment.
P S
OWER WITCH
Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions:
"I" (one) for ON and "0" (zero) for OFF.
S C
ETTING THE
The unit contains a clock, which is used for system maintenance and event tracking.
After the unit has been turned on
"Would you like to change the clock from GMT to local time - if YES press Enter - if NO press
Clear"
It is not mandatory to change the clock setting. To accept the current settings, press the CLEAR
key.
To change the setting, press the ENTER key. The MESSAGE CENTER displays: "CHOOSE
DISPLAY MODE - 12 HOUR MODE AM PM". Use an ARROW key to toggle the setting to
CHOOSE DISPLAY MODE - 24 HOUR MODE. To accept the mode, press the ENTER key.
The current time (in Greenwich Mean Time) will be displayed.
• Use the TIME arrows to change the hours
• Use the INCLINE arrows to change the minutes
• Use the SPEED arrows to change the seconds
When finished press the ENTER key. The MESSAGE CENTER displays "UPDATING CLOCK".
At this point, the clock has been reset, and the normal startup procedure continues.
This prompt appears for the first five times that the unit is turned on, including power-ups at the
†
factory.
12
S
TABILIZE THE
LOCK
, the display will prompt for the following:
†
L F T
IFE ITNESS READMILL