Eiki LC-WUL100 Owner's Manual page 57

Lamp control
Lamp control
This function allows you to change brightness of the
screen.
Auto . . . . Brightness according to the input signal.
Normal . . Normal brightness.
Eco 1 . . . Lower brightness and decrease of fan speed.
Lower brightness reduces the lamp power
consumption and extends the lamp life.
Eco 2 . . . Lower brightness and increase of fan speed.
Lower brightness reduces the lamp power
consumption and extends the lamp life. It is
recommended to use Eco 2 when using the
projector continuously over a long period of
time. The fan noise becomes louder in Eco
2 than in Eco 1. Select the suitable mode for
the operating environment.
Note:
The fan noise becomes louder in Eco 2 than in Eco 1.
Select the suitable mode for the operating environment.
Lamp life control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 ....... The lamp can be turned on even after
exceeding the recommended total hours of
use.
Mode 2 ....... The lamp can be turned on even after
exceeding the recommended total
hours of use. But the projector turns off
automatically after 3 minutes.
Note:
• L amp mode cannot be changed for a while after
turning on the projector. Lamp needs some time to
stabilize after the power is turned on. Stored lamp
mode will be active after the lamp is stabilized.
• If Mode 2 has been selected and the projection lamp
exceeds the recommended total hours of use, the
replacement icon will be displayed at the time of
power-on.
Then the projector will turn off after 3 minutes.
Lamp replacement icon
The Lamp replacement icon will not appear when the
Display function is set to Off (p.52), during "Freeze"
(p.30), or "Shutter" (p.27).
Lamp life control
Setting
57