Martin Roboscan Pro 1220 Operator's Manual page 9

carefully insert it into the lamp socket.
6. Again, without touching the glass envelope with your fingers, turn the lamp around its centre-
axis until the small nipple on the bulb is straight up and thus facing the chassis plate when the
lamp module is replaced in the fixture. Then tighten the finger nuts on the lamp, thus securing
it to the holder.
7. Carefully clean the lamp using the cleaning cloth provided with the lamp.
8. Replace the lamp module and tighten the two finger screws.
9. Replace the main-cover by locating it back onto the fixture and then slide it towards the fan-
end of the fixture. It is necessary to replace the cover in this way as there are some securing
points along the side of the case which have to slide into one another to secure the cover cor-
rectly. When the cover is in place, simply press the large section of the lock until it clicks and
latches into position.
M S R 1 2 0 0 L A M P
1. Place the Pro 1220 on a table so that the mirror is up.
2. Locate the snap-lock on the fan-end of the fixture and press the small section on the left hand
side of this lock, thus releasing the main cover. Now, slide the whole main-cover approxi-
mately 3 cm towards the mirror and then remove it upwards, being careful not to damage the
mirror while revealing the inside of the fixture.
3. Locate the lamp holder assembly at the fan end of the fixture and turn the two finger screws a
quarter turn counter clockwise, thus releasing the assembly from the reflector and lens-mod-
ules.
4. Withdraw the lamp socket assembly.
5. Hold the lamp in a clean cloth or by the ceramic base, avoiding touching the glass envelope
with your fingers, and then press it firmly into the lamp socket.
6. Carefully clean the lamp using the cleaning cloth provided with the lamp.
7. Replace the lamp holder assembly and tighten the two finger screws.
8. Replace the main-cover by locating it back onto the fixture and then slide it towards the fan-
end of the fixture. It's necessary to replace the cover in this way as there are some securing
points along the side of the case which have to slide into one another to secure the cover cor-
rectly. When the cover is in place, simply press the large section of the lock until it clicks and
latches into position.
NOTE: The lamp position has already been adjusted at the factory, however, re-adjustment may be
necessary to optimize the light output and the color uniformity from the CMY (Cyan, Magenta,
Yellow) system in the Pro 1220 CMYR. Please refer to section 6 - 'HARDWARE SETTINGS
AND ADJUSTMENTS'.
R obo sc a n Pr o 1 2 20 - ope ra tor' s ma nua l 9