Kodak ESP 7200 Series Start Here Manual page 27

Setting Up the Wireless (Wi-Fi) Connection
4. If the name of your network is:
Listed Not Listed
Press".. to select
Make sure your wireless router is turned on and within range. If your
your network, then
wireless router does not broadcast its SSID:
press OK.
a. Press".. to select Unlisted network, then press OK.
b. Use the LCD keyboard to enter your network name.
c. Select WEP
or
WPA/WPA2 as required for your network's security
setup, then press OK.
5. If your network has security enabled, use the LCD keyboard to enter your security string.
6. When the confirmation message appears, press OK.
If the printer is successfully connected, the Wi-Fi status light should be on.
If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking.
7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your
computer. Follow the on-screen instructions to complete your setup.
Connecting to a WPS wireless router
1. Press Home.
2. Press".. to select Network Settings, then press OK.
3. With WiFi Setup Wizard selected, press OK.
NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup Wizard.
4. With WPS Connect selected, press OK.
5. Select one of these two methods of connecting:
IMPORTANT: Before you press OK
on
the printer, make sure you know where the router's button is,
or
where
to
enter the generated PIN. If necessary, consult your Internet service provider
or
router
manufacturer's documentation for more information.
Pressing a Button Entering a PIN
a. With Push Button Configuration selected, press OK. a. Press".. to select Generate WPS
b. Press or select the WPS button for your wireless
PIN, then press OK.
router. b. In your wireless router's software,
NOTE: You will have two minutes to press or select the
locate the PI N screen.
WPS button. It may be a button on the device c. Enter the PI N you received from
or a virtual button in the device's software. the LCD into the PIN screen.
6. When the confirmation message appears, press OK.
If the printer is successfully connected, the Wi-Fi status light should be on.
If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking.
7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your
computer. Follow the on-screen instructions to complete your setup.
3
www.kodak.com/go/aiosupport