Brother P-Touch 3600 User Manual page 98

ERROR MESSAGE LIST
ERROR MESSAGE
TEXT TOO HIGH!
TEXT TOO LONG!
VALUE OUT OF RANGE!
CHECK VALUE AND
RE-ENTER.
WRONG ADAPTER!
WRONG CHARACTER!
88
CAUSE
G This message appears if the size
of the text is larger than the
width of the installed tape.
G (PT-9600 only) This message
appears if the Lines of Text set-
ting for the ESC/P interface
mode exceeds the maximum
possible for the installed tape.
G This message appears if the
length of the text is longer than
the label length that has been
set with the Tape length func-
tion.
G This message appears if you try
to print a label that is longer
than the maximum label length.
G This message appears if you try
to print a label that is longer
than the maximum label length
or is longer than the specified
block length.
G This message appears if the
length of the text is longer than
the width of the tape when the
Text rotation function is used.
G This message appears if the
value entered while setting the
Tape margin, Tape length,
Block margin and Block length
function is not within the allow-
able range.
G
This message appears if the
specified characters cannot be
found in the database.
G This message appears if the val-
ues for the records to be printed
is not within the allowable
range.
G This message appears if an
extremely high-voltage
extremely low-voltage adapter
is being used.
G This message appears if a time
stamp or user-defined character
image is selected when you try
to use the Numbering function.
SOLUTION
G Reduce the size of the
characters, install a tape
with a greater width or
select the AUTO text size
setting.
G Specify the correct setting
for the installed tape.
G Delete some of the text,
reduce the character
width, or increase the set
label length.
G Delete some of the text or
reduce the character size.
G Type in a value that is
within the allowable
range.
G Disconnect the adapter,
or and connect the adapter
designed exclusively for
this machine.
G Select text or a barcode
before trying to use the
Numbering function.