Brother P-Touch 3600 User Manual page 91

To change the HEAD ADJUSTMENT setting:
This function allows you to shift the printing up
or down within the tape.
NOTE
This function does not adjust printing on 36-mm-
wide tape.
1 Hold down d and press A.
NOTE
This step may be skipped if settings for several
Setup functions are being applied at the same time.
2 Rotate r until HEAD ADJUSTMENT is dis-
played, and then press r (OR press j or
k until HEAD ADJUSTMENT is dis-
played).
1 2 3 4 5 6 7 8 9 A B C D E F K Q Q Q Q Q
R
R
G
03/05
R
H NO
R HEAD ADJUSTMENT
L M
R
I
00
R
J
AUTO 0.4
Length Margin
3 Rotate r (or press m or g) until the
desired setting is displayed.
NOTE
To return the function to its default setting (0),
press the space bar.
To shift the printing down, select a lower value.
To shift the printing up, select a higher value.
4 Press r (or press n) to apply the setting.
NOTE
If r is used to select the settings, only one function
can be set at a time. To apply several Setup settings
at the same time, press j or k to select the func-
tion, and then press m or g to select the desired
setting. Press n only after the necessary functions
have been set.
To change the HALF CUTTER setting:
This function allows you to adjust how deep a
half cut is cut with laminated tape, for example, if
the tape is cut too much or not enough. Nor-
mally, it is only necessary to change the setting
by one. If the half cut is still either too deep or not
deep enough, change the setting by one again.
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
Ch. 4 Machine Adjustments
NOTE
If the tape is still not cut correctly even after this set-
ting has been continuously adjusted, the cutter may
be dull. Contact your service representative.
1 Hold down d and press A.
NOTE
This step may be skipped if settings for several
Setup functions are being applied at the same time.
2 Rotate r until HALF CUTTER is displayed,
and then press r (OR press j or k until
HALF CUTTER is displayed).
1 2 3 4 5 6 7 8 9 A B C D E F K Q Q Q Q Q
R
R
G
04/05
R
H NO
R HALF CUTTER
L
R
I
M
00±3
R
J
AUTO 0.4
Length Margin
3 Rotate r (or press m or g) until the
desired setting is displayed.
NOTE
To cut less deep, select a lower value. To cut
deeper, select a higher value.
Adjust the setting in small steps.
To return the function to its default setting (0),
press the space bar.
4 Press r (or press n) to apply the setting.
NOTE
If r is used to select the settings, only one function
can be set at a time. To apply several Setup settings
at the same time, press j or k to select the func-
tion, and then press m or g to select the desired
setting. Press n only after the necessary functions
have been set.
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
81