Connecting The P-Touch To A Computer - Brother P-Touch 3600 User Manual

Ch. 2 Getting Started
4 Insert the tape cassette firmly into the tape
compartment, making sure that the entire
back of the cassette touches the bottom of
the compartment.
NOTE
When inserting the tape cassette, make sure that the
inner ribbon does not catch on the corner of the
metal guide.
.
P-touch 9600:
P-touch 3600:
5 Close the compartment cover, and then
press o to turn on the machine, if it is off.
The width of the currently installed tape is
shown by the tape width indicator on the
left edge of the display.
1 2 3 4 5 6 7 8 9
R
R
G
<<< P-touch >>>
R
H NO
R
L M
R
I
1:_
R
J
AUTO 0.4
Length Margin
6 Press f once to remove any slack in the
tape and cut off the excess.
10
K Q Q Q Q Q
A B C D E F
Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
HELSINKI A AUTO
Font Width Size
Connecting the P-touch to a
computer
G G G G G G G G G G G
This machine is equipped with a USB port,
allowing you to use a USB cable to connect the
P-touch to a computer running Windows
Mac OS, and print labels created using the
P-touch Editor software.
NOTE
Do not connect the P-touch to the computer before
installing the P-touch Editor software, otherwise it
may not be installed correctly. Follow the installa-
tion procedure on pages 11 through 27 to install
the P-touch Editor software and the printer driver,
and connect the P-touch to the computer when you
are instructed to do so.
To connect a computer to the P-touch
through the USB port:
1 Insert the flat (A) connector on the USB
cable into the USB port on the computer.
2 Insert the square (B) connector on the USB
cable into the USB port on the right side of
the P-touch.
3 Turn on the P-touch.
P-touch 9600:
P-touch 3600:
G G G G G G G G G G G
®
or