Location And Function Of Controls - LG GCE-8480B Owner's Manual

DirectCD TM v2.5b(s)
Front Panel
Rear Panel
Introduction

Location and Function of Controls

1. Headphone Jack
2. Volume Control
3. Emergency Eject Hole
4. Stop/Eject Button
5. Disc Tray
1. Digital Audio Output Connector
2. Analog Audio Output Connector
3. Jumper Connector
This jumper determines whether the drive is configured as a master or slave.
Changing the master-slave configuration takes effect after power-on reset.
4. IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin flat IDE
cable.
NOTE : Do not connect or disconnect the cable when the power is on, as this could
cause a short circuit and damage the system. Always turn the power OFF when
connecting or disconnecting the cable.
5. Power Connector
5
1 2
3
6. Drive activity indicators
Two colored LEDs are used to indicate
the operation of CD-R/RW Drive.
(1) Read
The orange LED is displayed when
the spindle motor begins the spin-up
operation: accessing data, reading
data, playing Audio, and opening
or closing the tray.
(2) Write
The green LED is used during disc
writing sessions.
1 2 3 4
6
5
4
5