Kenmore 795.75312.900 Service Manual page 9

Move the Hinge Pin Insert Bracket to the other side
of the door, keeping the same orientation, and move
the Hinge Pin Insert into the hole on the left side of
the bracket.
Reverse Door Closer/Stop by flipping over, place on
top of Hinge Pin Insert Bracket, and tighten both
down with the screw.
Pry off cover on top of refrigerator on left side to
uncover screw holes.
Set freezer door and Top Hinge parts to the side and
remove refrigerator door.
Reverse Refrigerator Door
Before reversing the door, remove the Base Grille.
Remove the cover on the left side of base grille and
place it on the right side.
Locate the quick connector next to the Bottom Hinge
and disassemble with the next steps:
1. Remove locking clip 1 and set aside.
2. Press back collet and pull out water connection
tube 2 .
Fig. 4
1
Tube
Insert lines
Locking clip
Carefully disconnect wire harness connectors next
to Bottom Hinge.
As described in Remove Refrigerator Door.
- 9 -
Bottom Hinge
connector
2
Connector