Kenmore 795.75312.900 Service Manual page 7

Loosen and remove the 2 bolts and the phillips head
screw to remove the Middle Hinge Bracket from
refrigerator cabinet (Fig.7 and 8). Set parts aside.
Lift up the door watching carefully that the wire
harness and water tube don't get damaged by
the bottom hinge.
Replace Refrigerator Door
Insert the water tube and wire harness trough the
bottom hinge. Being careful not to damage the water
tube or wire harness, feed them trough the hole in
the hinge plate.
Note: Make sure to align Hinge Pin with bottom
hinge to assure proper assembly.
• Install the hinge pin into the bottom hinge.
• Using an adjustable wrench reinstall the bottom nut
making sure it is tight.
Fig. 10
Hinge Pin
Bottom
Hinge
Bottom Nut
Reinstall the Middle Hinge with the two bolts and a
phillips screw.
Place washer between refrigerator door and middle
hinge
Once the refrigerator door is installed, reconnect
wire harness, water tube and connector. There are
two insert lines at the end of the tube. Insert the tube
far enough into the connector until you can only see
one line. Replace the locking clip.
Fig. 13
Tube
Insert lines
Locking clip
- 7 -
Bottom Hinge
connector
Connector