Kenmore 795.75312.900 Service Manual page 10

Using an adjustable wrench remove Bottom Nut.
As described in Remove Refrigerator Door.
Insert flat blade screwdriver into corner notches on
bottom of dispenser cover. Pry base off cover loose.
CAREFULLY pull cover forward to detach clips on
sides and top of cover, and disconnect the wire
connector on the back of the dispenser cover.
Set cover aside.
Use phillips screwdriver to remove tube guide screw.
Pull tube all the way up and out of door.
Set tube aside.
Using a 1/4" socket wrench, loosen and remove hinge
pin from the middle hinge pin bracket.
Remove washer underneath the middle hinge and
set aside.
Lift up door watching carefully that wire harness
doesn't get damaged by the Hinge Pin.
Using a 10mm or 13/32 inch socket wrench remove Middle
hinge Bracket and set aside.
Using a 13/32" 10mm socket wrench with 2"extension,
loosen the 3 bolts and remove bottom hinge from right side.
Remove the bolt on bottom of refrigerator from the left side
and insert it on the right side.
You will need this hole for the Bottom Hinge.
Move the Bottom Hinge to the left side keeping the
same orientation and attach 3 bolts.
- 10 -