Table of Contents
Advertisement
4. Removal of DECK ASSY
1. Remove the Top Cover.
(Refer to Para. 1 of the DISASSEMBLY.)
2. Remove the Front Panel.
(Refer to Para. 2 of the DISASSEMBLY.)
3. Short-circuit the cathode side of D927 and the GND of
the DECK ASSY using the jig shown below.
Note: The CAPSTAN MOTOR may be damaged without
above short circuit.
4. Remove the one screw (a) and remove PCB HA Holder.
5. Disconnect the Connectors HH and HK on PCB-HEAD
AMP.
6. Remove the two screws (b) shown in Fig. 4 and raise
the PCB-HEAD AMP to remove it.
7. Remove the four screws (c) shown in Fig. 5.
8. Disconnect the Connectors MA, MD and ML on PCB-
MAIN.
9. Release the two catches (d) shown in Fig.5 and raise
the DECK ASSY to remove it.
Note1:Remove the DECK ASSY paying attention to the
Connectors MC and MF under it.
Note2:Short-circuit the cathode side of D927 and the Shield
Plate using the jig shown below before attaching the
DECK ASSY.
Jig (Part No. : 859C548O10)
3W 330Ω
PCB HA Holder
HK
PCB-HEAD AMP
Connector MF
Connector MC
- 6 -
a
b
HH
Fig. 4
c
DECK ASSY
d
c
Fig. 5
Advertisement
Table of Contents
