Table of Contents
Advertisement
2-8. Front Control Module Removal
Remove the two screws fixing the user control module to the
front underside of the set. The control module drops down to
allow access to the boards.
2-10. H5 Board Removal
To remove the H5 Board, first remove the control door from
bracket by releasing the clips circled and pushing them
through the main support bracket.
Clips
Removal of H5 Board follows the same procedure as removal
of the F3 and H6 Boards.
2-9. F3 and H6 Board Removal
To remove the F3 and H6 Boards release the clips circled and
ease the boards gently away from the main support bracket.
Screws
2-11. Service Connector for H5 Board
If there is a requirement to use the front video and audio
sockets when the chassis is placed in its service position, it
would be necessary to use an extender board and extension
cable as indicated below.
The Extender board and extension cable are available as a
service part by ordering the part number as indicated.
17
Clips
To CN 1703 on
A Board
Extender board assembly A-1647-037-A
From H5 Board
Hide quick links:
Advertisement
Table of Contents
