Table of Contents
Advertisement
5.8
Random Trigger Shutter
An image is captured at the desired timing using trigger signal input. External trigger signal from
trigger input connector and software trigger from control command via the USB 3.0 interface are
available (Only in Edge mode). Trigger polarity is selectable (High active / Low active).
Note that Random Trigger Shutter will cause a delay between trigger signal and start of exposure.
See 7. Timing Chart for detail.
- Edge mode (TriggerSequence0)
The exposure time is determined by Exposure Time setting.
- Level mode (TriggerSequence1)
The exposure time is determined by the pulse width of the trigger signal.
- Bulk mode (TriggerSequence6)
Camera exposes and transfers multiple frames by a single trigger.
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
Trigger
Exposure
USB bus
Trigger
Exposure
USB bus
Trigger
ExposureTime
Exposure
USB bus
ExposureTime
Image
Pulse Width
Image
TriggerAdditionalParameter = 3
Image
Image
9
Image
D4212818G
www.toshiba-teli.co.jp
Advertisement
Table of Contents
