Table of Contents
Advertisement
3. Pivot off bottom plate making
sure to unhook center tab on
inside edge of nozzle (opposite
edge with screws).
4. If belt is stretched, remove it
from the motor pulley.
Remove agitator and belt from
nozzle.
5. Put new belt on agitator.
Position agitator in nozzle orient-
ing agitator end caps with slots on
both sides of nozzle. End cap
with side projections fits into slot
opposite the end with nozzle
latch.
The agitator end caps may fall off
during belt replacement. For
correct orientation of end caps
onto agitator, see "How to replace
Agitator Brush."
The belt should line up with tab on
inside of nozzle.
9
Hide quick links:
Advertisement
Table of Contents
