Advertisement
2 1/8"
Self Drilling Screw
or Nail Location
Limit
Crossover Wire K Series
VOID in CB Series
CB Ceramic Element Baseboard Heater
The CB Series baseboard heater has the return wire within the
element and the wireway is empty, (see Figure 4). If your power
supply is on the right side you will need to cut the loop to apply
your power. If the power supply is on the left, cut one connec-
tor to apply power supply similar to diagram in Figure 5.
K Series Element Baseboard Heater
Cut to Apply Power to
LEFT SIDE
Power Supply Connection
LEFT SIDE
SUPPLY WIRES
HEATER WIRES
Connection Diagram for Wall Mounted Single Pole Thermostat
1. Red thermostat wire to black power supply wire.
2. Black thermostat wire to black heater wire.
3. White power supply wire to white heater wire.
4. Connect all bare groundwires together.
Screwdriver Bit
or Nailing Tool
Location
Air Guide
Element
Figure 4
Cut to Apply Power to
RIGHT SIDE
Figure 5
Power Supply Connection
RIGHT SIDE
6. Follow the desired wiring diagram, as shown in Figure 5, to
connect the power supply to the heater using approved wire
nuts.
NOTE: When accessories are installed, use wiring diagram sup-
plied with the accessory.
7. If front cover was removed, reinstall by hooking the top edge
on the support bracket(s). Then push down to latch onto the
support bracket(s).
8.Replace wiring compartment cover(s).
9.Follow instructions accompanying thermostat for installation
and wiring thermostat. Visit www.king-electric.com for typical
thermostat wiring diagrams.
Instructions for Left or Right Side Wiring
1.
Heater can be wired from either side - wire
one side only.
2.
Cut one factory splice cap as shown.
3.
This leaves two wires for power connection.
4.
Caution: Do not cut both factory splice caps
on left side - you need only two wires for
power connection.
Connection Diagram for Wall Thermostat
1.
Connect power supply wires from wall thermo-
stat as shown.
2.
Black and white supply wires can be connected
3.
to the heater in reverse order. For simplicity
the
4.
most common method is shown.
5.
Connect bare groundwire to green groundwire.
WIRE COLOR CHART
BLACK WIRE
RED WIRE
BARE GROUNDWIRE
WHITE WIRE
Connection Diagram for Wall Mounted Double Pole Thermostat
1.
Connect the two red thermostat wires to the black and
white power supply wires.
2.
Connect the two black thermostat wires to the black and
White heater wires.
3.
Connect all the bare groundwires together.
SUPPLY WIRES
HEATER WIRES
Advertisement
