Table of Contents
Advertisement
AGITATOR END 1
3. Pull out shaft part way, then
reinsert shaft to push out opposite
agitator end.
4. Remove shaft, being careful to
leave washer on shaft
5. Insert into other end to push out
second agitator end.
6. Discard old agitator brush roll.
7. Place agitator ends into new
brush roll, matching projections in
roll with openings in ends. Push
ends firmly into place. (If bearing
comes out of agitator end during
disassembly, place washer and
bearing back into agitator end, with
white side of bearing out, before
inserting shaft.)
8. Insert shaft (with washer) into
agitator. Replace end plate and
tighten.
Note: Be sure shaft is inserted so
that the end plate with the flat sided
projection is screwed onto belt end
of agitator roll.
Use this illustration for reassembly,
if necessary. Washer must be
placed between agitator ends and
bearing.
9. Replace agitator as shown in
steps
of "How to repiace belt".
16
Advertisement
Table of Contents
