Description Of Function And Circuit Of Micom - Kenmore 795.78542.801 Service Manual

8. DESCRIPTION OF FUNCTION & CIRCUIT OF MICOM
8-1 FUNCTION
8-1-1 Function
1. When the appliance is plugged in, it is set to 37 for Refrigerator and 0 for freezer.
You can adjust the Refrigerator and the Freezer control temperature by pressing the ADJUST button.
2. When the power is initially applied or restored after a power failure, it is automatically set to 37 & 0.
8-1-2 How to Change the Temperature Mode to °F / °C
1. The setting temperature mode can be changed to °F / °C by pressing and holding Freezer Temp. key of Freezer and
Refrigerator Temp. key of Refrigerator over 5 seconds.
2. The initial setting is °F. Whenever the mode is changed, the LCD lights are changed.
8-1-3 Lock function (dispenser and display button lock)
1. In power application of refrigerator, the LOCK icon is turned off at the
upper side of lock graphic of display with the lock release status.
2. If desiring to lock the display the dispenser and control panel push on
the LOCK button more than 3 seconds. LOCK text is turned on at the
upper side of lock graphic of display with lock status.
3. The buzzer sound and control panel and dispenser function is not
performed even if pressing display button other than lock key in the
lock status.
4. If desiring to release the lock status and pressing the lock button more
than 3 seconds. LOCK icon is turned off at the upper side of lock graphic of display with the lock release status.
8-1-4 Filter condition display function
1. There is a replacement indicator icon for the water
filter cartridge on the dispenser.
2. Water filter needs replacement every months.
3. Water filter icon turns on to tell you need to replace
the filter soon.
4. After replace the filter, press and hold the lock button
more than 3 seconds.
Then water filter light turns off with reset status.
8-1-5 Ultra Ice selection
Please select this function for prompt freezer.
• Function is repeated following below whenever pressing Ultra Ice button.
• Ultra Ice function automatically turns off if a fixed time passes.
In initial Power On
Classification
/ Filter RESET
Filter Status
Display
- 26 -
Ex) In selecting Ex) In selecting
LOCK LOCK again
Replace indicator
light on