Pj Com Connection; Connection Example - Sony VPL-FE110U Protocol Manual

6-3. PJ COM CONNECTION

Port for connecting PROJECTOR and SWITCHER.
Communication is enabled by using the normal 9Pin D-Sub straight (normal) cable (RS-232C cable). This
however applies to cables which are connected to all pins only.
Note : Connect all models by cascade connection and terminate each.
Assured cable length : 50 m (However, assurance may not be applicable for some cables.)
The total length including extension should be within 500 m.

6-4. CONNECTION EXAMPLE

System consisting of two SWITCHERs and two PROJECTORs.
Controller
RS-232C
or
Switcher
RS-422A
No.1
Switcher
No.2
Connect CONTROLLER to the RS-232C Port of the nearest unit.
Connect PROJECTOR and SWITCHER using the PJ COM Port.
8
In
Projector
No.1
Out
PJ COM
In
Projector
In T
No.2
T Out
Out
In
Out
VPL-FE110U/FE110M