Connection Examples - Sony VPL-S800U Operating Instructions Manual

Connection Examples

For details on how to connect a computer, a VCR or
external active speakers, see page 18 (EN). Also refer
to the instruction manual of the equipment to be
connected.
When making connections, be sure to:
• turn off all equipment before making any
connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
Connecting a BNC connector
2 Twist to the right.
1 Align the pins with the pin holes and
push in the plug into the socket.
To set the index number
You have to set the index number when you use the
multiple projectors. Set the index number so that you
can select the projector to be operated with the Remote
Commander. The index number is set with the INDEX
switches. The index number is set to "01" at the
factory. When using only one projector, set the number
to "01".
Ten's digit
0
Notes
• Do not use the same index number twice in one
system.
• Do not separate two index numbers in one system by
more than eight numbers.
• Do not use the number "9" if you use the supplied
Remote Commander for selecting the index number.
• Do not set the number to "00". If it is set to "00", the
projector does not work.
Unit's digit
41
(EN)