Shutter Button Unit, Lithium (2Nd) Battery - Canon PowerShot S400 Service Manual

CHAPTER 3. REPAIR INSTRUCTION
i
(2)-1
(2)-1
SHIELD SHEET UNIT
FINDER GAP SPACER
i
XA1-7170-357
3.5mm
SILVER
M1.7
Fig. 3-8 SHUTTER BUTTON UNIT, LITHIUM (2ND) BATTERY

2.6 SHUTTER BUTTON UNIT, LITHIUM (2ND) BATTERY

(1) SHUTTER BUTTON UNIT
1. Remove the FINDER GAP SPACER in the direction of arrow.
2. Remove the two claws and remove the SHUTTER BUTTON UNIT.
(2) LITHIUM (2ND) BATTERY
1. Remove the two screws of i, and open the SHIELD SHEET UNIT.
NOTE1 (Assembling)
Fold the tongue-like plate of the SHIELD SHEET UNIT toward inside of the notch as shown in the figure.
2. Remove the LITHIUM (2ND) BATTERY.
NOTE2 (Assembling)
Be careful not to make mistake about (+) and (-) direction.
Claw
(1)-1
NOTE2 (Assembling)
Be careful not to make
mistake about the direction
of + and -.
(1)-2
SHUTTER BUTTON UNIT
NOTE1 (Assembling)
Fold the tongue-like plate of
the SHIELD SHEET UNIT
toward inside of the notch as
shown in the figure.
(2)-2
LITHIUM (2ND) BATTERY
3-8