Arctic Cat Diesel SD 700 2011 Service Manual page 25

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
9. Block the rear of the engine up; then remove the
rear mounts from the transmission.
10. Remove five cap screws securing the transmission
to the V-belt housing; then remove four cap screws
securing the engine-to-transmission mounting
plate.
24
11. Slide the transmission to the left side until the rear
output flanges can be separated; then move the
transmission to the rear to expose the front output
yoke boot.
12. Slide the boot off the yoke and separate the front
propeller shaft from the front output drive yoke.
Top-Side Components
NOTE: For efficiency, it is preferable to remove
DE085A
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
SPEED GOVERNOR
DE090A
Removing/Disassembling
1. Remove the timing belt (see Left-Side Compo-
nents in this section).
2. Remove the air filter assembly; then remove the
valve cover.
DE589A
3. Disconnect the throttle cable; then remove the cap
screws securing the intake manifold/throttle cable
housing to the cylinder head.
www.mymowerparts.com
DE487
Manual
Table of Contents
AT THIS POINT
DE074