Arctic Cat Diesel SD 700 2011 Service Manual page 10

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
3. Tighten the jam nut against the throttle cable
adjuster securely; then slide the rubber boot over
the adjuster.
Engine RPM (Idle)
NOTE: The idle RPM is not adjustable on the 700
Diesel.
Engine Oil - Filter
Change the engine oil and oil filter at the scheduled
intervals. The engine should always be warm when the
oil is changed so the oil will drain easily and com-
pletely.
1. Park the ATV on level ground.
2. Remove the engine oil filler cap.
3. Remove the drain plug from the bottom of the
engine and drain the oil into a drain pan.
ATV-0047C
4. Remove the right-side engine cover.
5. Using a suitable filter wrench, remove the oil fil-
ter.
NOTE: Clean up any excess oil after removing
the filter.
6. Apply oil to a new filter O-ring and check to make
sure it is positioned correctly; then install the new
oil filter. Tighten until contact is made; then
tighten an additional 3/4 turn.
NOTE: Install a new O-ring each time the filter is
replaced.
7. Install the engine drain plug and tighten to 18 ft-lb.
Pour the specified amount of the recommended oil
in the filler hole. Install the oil filler cap.
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use racing,
vegetable, non-detergent, and castor-based oils.
DE025A
8. Start the engine (while the ATV is outside on level
ground) and allow it to idle for a few minutes.
9. Turn the engine off and wait approximately three
minutes.
10. Remove the oil level stick and wipe it with a clean
cloth.
www.mymowerparts.com
Manual
Table of Contents
CAUTION
DE017A
DE018
9