FocusPRO
™
TH6220D Programmable Thermostat
Wallplate installation
Insert finger into wire hole and pull to
remove wallplate from thermostat.
Insert quick reference card
Drill 3/16" holes for drywall.
Drill 7/32" holes for plaster.
Wall anchors
Remove the wallplate from the ther-
mostat as shown at left, then follow
directions below for mounting.
1 Insert quick reference card in slot
in back of thermostat.
2 Pull wires through wire hole.
3 Position wallplate on wall, level and
mark hole positions with pencil.
4 Drill holes at marked positions as
shown below, then tap in supplied
wall anchors.
5 Place wallplate over anchors, insert
and tighten mounting screws.
Wire hole
3
Mounting screws