JVC UX-M3R Service Manual page 10

UX-M3R
<Front panel assembly section>
Remove the left and right side panels.
Remove the top cover.
Remove the front panel assembly.
Removing the key board
Remove the ten screws P retaining the key board.
Removing the cassette mechanism
assembly
1. Remove the two screws Q and the two screws R
retaining the cassette mechanism assembly.
2. Remove the tie band bundling the REC/PB head
wire.
[Caution] After assembly, apply a locking agent
to the screws Q and R.
Removing the cassette door damper
Remove the screw S retaining the damper bracket
and take out the cassette door damper.
Removing the cassette door stopper
Remove the two screws T retaining the cassette
door stopper and remove the cassette door
stopper.
Removing the cassette door cover
[Note] Use the following procedure to remove
only the cassette door cover.
This procedure does not require the
removal of exterior parts such as the
side panels.
1. Open the cassette door.
2. Slide the cassette door cover in the direction of the
arrow and disengage the two claws f and the two
claws g on the left and right of the cassette door
cover from the cassette door.
Removing the cassette door
Remove the cassette mechanism assembly.
Remove the cassette door cover.
1. Open the cassette door, disengage the spring
hooked across the front of the front panel assembly
and the cassette door in the outward direction, and
remove it from the claw h.
2. From the back side of the front panel assembly,
remove the two screws U retaining the bracket.
3. While pushing the arm section i of the cassette
door in the direction of the arrow, remove the shaft
section j of the cassette door from the front panel
assembly.
4. While pushing the cassette door arm section k in
the direction of the arrow, remove the shaft section
m of the cassette door from the front panel
assembly.
5. Take out the cassette door from the back side of
the front panel assembly.
[Caution] In the assembly, be sure to put the
spring around the shaft j before
attaching the cassette door.
1-10
(See Fig. 19.)
(See Fig. 19.)
(See Fig. 19.)
(See Fig. 19.)
(See Fig. 20.)
(See Figs. 21 and 22.)
Front panel assembly
P
Cassette door
sttoper
T
S
Damper bracker
Cassette door
R
damper
Fig.19
Cassette door
Claw f
Claw g
Cassette door cover
Fig.20
Fig.21
Arm section i
Shaft section j
Spring
U
Fig.22
Key board
P
Q
Cassette
mechanism
assembly
R
Tie band
REC/PB head wire
Front panel assembly
Spring
Claw h
Disengage the spring so
that it comes to the front
of the claw h.
Front panel assembly
Arm section k
Shaft section m
Bracket