Gear (Stocker Communication); How To Install The Cam (Stocker U/D) - Aiwa CX-BK7 Service Manual

CX-BK7
4-5. HOW TO INSTALL THE ROTARY ENCODER (S702), GEAR (STOCKER COMMUNICATION)
Engage the rotary encoder (S702)
and the gear (stocker communication)
as shown below in the figure.
rotary encoder
(S702)
gear
(stocker
communication)
– rear –
4-6.

HOW TO INSTALL THE CAM (STOCKER U/D)

cam (stocker U/D)
f mark
f mark
cam (stocker U/D)
To install three cams (stocker U/D), align each groove
of the cam (stocker U/D) with each f mark on the
chassis as shown in the figure.
24
4 gear
(stocker communication)
3 screw
(PWH2 × 6)
1 rotary encoder
(S702)
rotary encoder
(S702)
screw
3 screw
(PTPWH2.6 × 8)
2 cam (stocker U/D)
cam (stocker U/D)
f mark
5 screw
(PTPWH2.6 × 8)
7 two screws
(PTPWH2.6 × 8)
6 two gears
(stocker communication)
2 five solders
relay board
1 Position the hole on the gear
(stocker communication) on the
screw of the rotary encoder (S702).
hole
gear
(stocker communication)
– rear –
3 two screws
(PTPWH2.6 × 8)
2 two cams
(stocker U/D)