Honeywell T7200D Product Data page 6

T7200D,E, T7300D,E,F AND Q7300 SERIES 2000 PROGRAMMABLE COMMERCIAL THERMOSTATS AND SUBBASES
SUBBASE
T
T7047C
T T
T7047C
T T
Fig. 5. Two T7047C Sensors and one T7047G Sensor
providing temperature averaging network for
T7300/Q7300 Thermostat/Subbase.
T
T7047C
T T
T7047C
T T
Fig. 6. Four T7047C Sensors providing temperature
averaging network for T7300/Q7300 Thermostat/Subbase.
SUBBASE
T T
T7047G
T7047G
T
T
T7047G T7047G
T
T
Fig. 7. Five T7047G Sensors providing temperature
averaging network for T7300/Q7300 Thermostat/Subbase.
63-4355—4
T
T7047G
T T
M4839
SUBBASE
T
T7047C
T T
T7047C
T T
M4840
T
T T7047G
T
T
T
T
M4841
T7047C
T T
T7047C
T T
T7047C
T T
Fig. 8. Nine T7047C Sensors providing temperature
averaging network for T7300/Q7300 Thermostat/Subbase.
NOTE: With the thermostat configured for a temperature
averaging network (remote and internal sensing), the
internal sensor has 50% authority of the averaged
temperature.
Mounting Subbase/Wallplate
The subbase/wallplate mounts horizontally on the wall or
a 2 in. by 4 in. wiring box. Position the subbase/wallplate
horizontally on the wall or on a 2 in. by 4 in. wiring box.
1. Position and level the subbase/wallplate.
NOTE: A level wallplate is only for appearance. The
thermostat functions properly when not level.
2. Use a pencil to mark the mounting holes. See Fig. 9.
3. Remove the subbase/wallplate from the wall and drill
two 3/16 inch holes in the wall (if drywall) as marked.
For firmer material such as plaster or wood, drill two
7/32 inch holes. Gently tap anchors (provided) into the
drilled holes until flush with the wall.
4. Position the subbase/wallplate over the holes, pulling
wires through the wiring opening.
5. Loosely insert the mounting screws into the holes.
6. Tighten mounting screws.
6
SUBBASE
T T
T7047C T7047C
T T T T
T7047C T7047C
T T T T
T7047C T7047C
T T T T
M4842