Canon PIXMA MP950 Service Manual page 33

5) Press the ON/OFF button to complete a button and LCD test and to return to the service mode menu selection.
<Waste ink amount setting procedures>
Set the waste ink amount data to a replaced new EEPROM after the logic board is replaced in servicing.
1) Before replacement of the logic board ass'y, check the waste ink amount in EEPROM information print.
EEPROM information print.]
2) In the waste ink amount setting mode, press the Stop/Reset button the specified number of time(s) according to the waste ink absorber whose
value should be transferred to the replaced new EEPROM. (Only the main waste ink absorber for the MP950)
Time(s)
0 times Main waste ink absorber
1 time Platen waste ink absorber
Both the main and platen waste ink absorbers
2 times
3 times or more Not valid
3) Press the ON/OFF button to proceed to the next step.
4) The waste ink amount can be set in 10% increments by pressing the Stop/Reset button. Press the Stop/Reset button the appropriate number of
time(s) to select the value which is closest to the actual waste ink amount.
Time(s)
0 times
1 time
2 times
3 times
4 times
Waste ink absorber
Waste ink amount value to be set (%)
0%
10%
20%
30%
40%
Not valid for the MP950
Only the main waste ink absorber is valid for the MP950
Press the ON/OFF button to return to the waste ink amount setting
mode.
1-28
[See 3-4. Verification Items, (2)
Remarks