VEC1089ABD 2/10/15 Amp 12 Volt Smart BATTERY CHARGER USER’S MANUAL & WARRANTY INFORMATION I I I I M M M M P P P P O O O O R R R R T T T T A A A A N N N N T T T T S S S S A A A A F F F F E E E E T T T T Y Y Y Y I I I I N N N N F F F F O O O O R R R R M M M M A A A A T T T T I I I I O O O O N N N N , , , , S S S S A A A A V V V V E E E E T T T T H H H H E E E E S S S S E E E E I I I I N N N N S S S S T T T T R R R R U U U U C C C C T T T T I I I I O O O O N N N N S S S S TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND THIS INSTRUCTIONAL MANUAL.
IMPORTANT SAFETY INSTRUCTIONS Figure Figure ADAPTER (B) WARNING — RISK OF EXPLOSIVE GASES 1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR GROUNDING CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
INTRODUCTION 4. Determine which post of battery is grounded (connected) to the chassis. If NEGATIVE post is grounded to chassis (as in most vehicles), see 5. If POSITIVE post is grounded to the chassis, see 6. Thank you for selecting the 2/10/15 Amp 12 Volt Smart Battery Charger. 5.
internal chemical energy transfer. At the end of Stage 2, the charger will signal "beep" the microprocessor and will stop charging if the rate is too fast or too slow for battery and move into Stage 3 charge mode. size or condition. Stage Three —...
OPERATING INSTRUCTIONS 4. Pressing the 2/10/15 AMP button repeatedly advances to standby mode; the unit sounds a beep, displays “000” and stops charging. The battery charger Ensure that all installation and operating instructions and safety displays the charge current. To view the battery voltage, press BATTERY VOLTAGE precautions are understood and carefully followed by anyone button.
Alternator Check 6. Fill the battery with distilled water according to the manufacturer’s instructions. Since batteries may rapidly bubble while being charged, remember to refill (only Part 1 with distilled water) after the equalization process is complete and the voltage is No Load (Turn OFF all vehicle’s accessories): The battery must be fully charged back to normal.
should it be charged at the 15 amp rate? See the chart above under “50%” and “at TROUBLESHOOTING 15 amp rate.” Display Indications/Common Problems/Possible Solutions In most cases, battery charging times will vary depending on the size, age and condition of the battery. Smaller batteries should be charged at a lower rate (2 amps) No Functions and an extra hour added to charge time.