Power Cord - Brother QL-500 User Manual

10
Introduction
Do not use paint thinner, benzene,
alcohol or any other organic solvents to
clean the machine. Doing so may cause
damage to the surface finish. Use a soft,
dry cloth to clean the machine.
Do not put any heavy objects or objects
containing water on top of the machine.
If water or any foreign object enters the
machine, contact the retail outlet where
the machine was purchased or your
local authorized service center. If you
continue to use the machine with water
or a foreign object in the machine, the
machine may be damaged or personal
injury could result.
Follow these guidelines to avoid fire, electric shock, or other damage.

Power Cord

Use only the authorized power source
(120V AC) for the machine.
Use only the power cord included with
the machine.
Do not handle the power cord or plug if
your hands are wet.
Do not overload the electrical outlet
sockets with too many appliances or
plug the power cord into a damaged
electrical outlet.
Do not cut, damage, alter or place heavy
objects on the power cord.
Cutter
Do not touch the blade of the cutter.
Follow these guidelines to avoid fire, electric shock, or other damage.
Installation/Storage
Put the machine on a flat, stable surface
such as a desk.
WARNING
The electrical outlet should be close to
the machine and be easily accessible.
Do not touch the cutter. Personal injury
could result.
Do not expose the machine to direct
sunlight or near heaters or other hot
appliances, in any area exposed to
extremely high or low temperatures,
high humidity or dusty areas. Doing so
could cause the machine to malfunction.
Do not use the power cord if it is
damaged.
Ensure the power cord is correctly
inserted into the electrical outlet.
Always hold the power cord when
unplugging the power cord from or
plugging it into electrical outlet. Do not
pull on the power cord. The wire in the
electrical cord may become damaged.
If the machine will not be used for an
extended period, remove the power cord
from the electrical outlet.
Do not open the top cover when the
cutter is operating.
CAUTION
Do not put any heavy objects on top of
the machine.