Status Led Indications - Brother QL-500 User Manual

Status LED Indications

Lamp
Not lit
Lit
Flashing fast
Flashing slow
Turns off after flashing
fast ten times
Power is OFF.
Power is ON.
(Normally lit while power is on, the LED flashes during cleaning or if an
error has occurred.)
Indicates one of the following errors.
• Cutter error
• Label sensor error
(DK Roll not installed correctly, end of DK Roll, or label jam)
• DK Roll compartment cover is open during operation
• Incorrect DK Roll installed
• No DK Roll installed
Cooling
(Waiting for temperature of print head to lower)
System error
Turn the QL-500 off and then on again.
If this error re-occurs, contact the retail outlet where the QL-500 was
purchased or your local authorized service center.
Condition
15