Advertisement
WiFly QA5 IP
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remember
that the Male XLR connector is the input and the Female XLR con-
nector is the ouput. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "SLAu" is dis-
played. The unit is now set as the "Slave" unit. Each slave unit
must be set to the same setting.
4. Connect the first "Slave" unit to the "Master", and the "Slave" unit
should now start follow the "Master".
ADJ Products, LLC - www.adj.com - WiFly QA5 IP User Manual Page 12
Master-Slave Configuration
WiFly QA5 IP
With this feature you are able to control the unit with DMX without the need
of XLR cables. Your DMX controller must be connected to a ADJ WiFly
TransCeiver to use this function. You are able to communicate up to 400 feet
(open line of sight)
NOTE: The ADJ RFC control must be set to OFF to use this function.
See pages 10-11 to turn OFF ADJ RFC.
1. Turn on the WiFly function using the instructions on page 11.
2. Follow the instructions on page 11 to set the Wireless address. The
address must match the address set on the WiFly Transceiver.
3. After you have set the WiFly address, follow the DMX instructions on
pages 9-10 to select your desired DMX Channel mode and set your
DMX address.
4. Apply power to the ADJ WiFly Transceiver. The fixture must be set up
first before you apply power to WiFly Transceiver.
Note: If the sync does not work, switch the WiFly power off then on again.
WiFly QA5 IP
This feature will let you link units to run in a master-slave mode without the
use of XLR cables.
NOTE: The ADJ RFC control must be set to OFF on all the units to use
this function. See pages 10-11 to turn OFF ADJ RFC.
1. Follow the instructions on page 11 to set the Wireless address. The
addresses on each fixture must be the same.
2. After you have set the WiFly address, select your master unit and set
your desired operating mode.
3. Turn on the WiFly function using the instructions on page 11.
4. For the Slave units, put the unit in Slave mode. See page 15 Master-
Slave configuration when setting the unit as a Slave. Then switch ON the
WiFly power switch.
NOTE: If they do not sync up master-slave, switch the Master fixtures
WiFly power switch off then on again.
ADJ Products, LLC - www.adj.com - WiFly QA5 IP User Manual Page 13
WiFly Set Up
WiFly Master-Slave Set Up
Advertisement
