Advertisement
WiFly QA5 IP
modes. The Channel modes are listed below:
To run the 4 Channel Mode, press the MODE button until "Ch04"
is displayed. This is the 4 Channel DMX Mode.
To run the 5 Channel Mode, press the MODE button until "Ch05"
is displayed. This is the 5 Channel DMX Mode.
To run the 6 Channel Mode, press the MODE button until "Ch06"
is displayed. This is the 6 Channel DMX Mode.
To run the 10 Channel Mode, press the MODE button until "Ch10"
is displayed. This is the 10 Channel DMX Mode.
To run the 11 Channel Mode, press the MODE button until "Ch11"
is displayed. This is the 11 Channel DMX Mode.
5. Please see pages 18-23 for DMX values and traits.
6. After you have chosen your desired DMX Channel mode plug in
the fixture via the XLR connections to any standard DMX control-
ler.
Default Running Mode:
This is a default running mode. When this mode is activated all modes
will return to their default settings.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the
MODE button to exit.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote
Control). When this function is activated you can control the fixture
using the ADJ RFC. Please see the next page for ADJ RFC controls
and functions.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents "on" or "off".
2. Press the SET UP button until "rFXX" is displayed. "XX" repre-
sents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
WiFLY On/Off:
This function is used to turn the WiFly function on and off.
ADJ Products, LLC - www.adj.com - WiFly QA5 IP User Manual Page 10
Operating Instructions
WiFly QA5 IP
1. Plug the fixture in and press the MODE button until "rCXX" is dis-
played. "XX" represents a number between 00-15.
2. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
WiFLY Address:
This function is used to set the WiFly address. This address must
match the address that is set to WiFly TransCeiver or WiFly controller.
1. Plug the fixture in and press the MODE button until "rCXX" is dis-
played. "XX" represents a number between 00-15.
2. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
Dimmer Curve Setting:
1. Plug the fixture in and press the MODE button until "d.XXX" is dis-
played (DMX address setting). Press the SET UP button until
"dr-X" is displayed, "X" representing a number between 0-4.
2. There are 5 dimmer curve settings to choose from. Please see the
Dimmer Curve Diagram Chart on page 24 to see the settings and
their respective beginning and ending fade times.
ADJ Products, LLC - www.adj.com - WiFly QA5 IP User Manual Page 11
Operating Instructions
Advertisement
