Setup - Midi - TC-Helicon VoiceLive Play GTX User Manual

Setup - MIDI

MIDI Chan – Sets the channel that the VoiceLive Play GTX listens to for Notes infor-
mation
Make sure that your output/control (Keyboard, Computer etc ) device is set to the same channel as
the VoiceLive Play GTX
CC Chan – Sets the channel that the VoiceLive Play GTX listens to for CC informa-
tion
Make sure that your output device is set to the same channel as the GTX
MIDI Program Change and CC's are as follows:
Patch Change - General Program Change
Set Key - 30 (1E in hex)
Set Scale - 31 (1F in hex)
HIT Off/On - 28 (1C in hex) (0-63/64-127 for toggle)
TALK Off/On - 114 (72 in hex) (0-63/64-127 for toggle)
Split Dir – Looks at the defined region of the keyboard for Notes information.
There are two settings:
1 Above – Notes played above the Splitnote are registered for Notes information
2 Below – Notes played below the Splitnote are registered for Notes information
Filter – Ingores specific information, based on the setting.,
There are four settings:
1 None – All relevant MIDI data is processed
2 Prgchange - Ingores all Program Change information, if it is recieved
3. Sysex - Ignores Sysex information. This can prevent unwanted firmware updates.
4 PC+Sysex - Ignores both Sysex and Program Change information
Transpose – Transposes all incoming Notes information
Transposition is limited to four (4) octaves in either direction
Splitnote – Sets the note at which Split Above/Below is registered
17