Getting Started - NGS Artica Deluxe User Manual

USER'S MANUAL

GETTING STARTED

1 Switching on / off headset
Function Operation
Switch on Press the MFB button for 3-5 seconds, and
release it till the blue LED is on
Switch off Press the MFB button for 3-5 seconds, and
release it till the red LED is on
Note: In order to save power, the headset will automatically switch off if no devices can be
connected within 5 minutes after switching on.
2 Pairing the headset with Bluetooth devices
How to enter pairing mode
Function Operation
Enter Make sure the headset is off. Press and hold
pairing MFB button for 7-9 seconds, and release it till
mode the red and blue LEDS blink alternately
Note: The pairing mode will last 2 minutes, If the headset still can't pair with any Bluetooth
devices after 2 minutes, it will switch into standby mode automatically.
Pairing the headset with Bluetooth mobile phone
Please make sure your mobile phone has Bluetooth function that can be used.
Specific pairing procedures may vary with different mobile phone. Please refer
to your mobile phone manual for further information. Steps as follows:
1. Please keep the headset and mobile phone in the range of 1 meter when
pairing.
2. Make the headset enter into pairing mode (Please refer to "how to enter into
pairing mode").
3. Start the Bluetooth function of mobile phone and search the Bluetooth
devices. After searched, select "NGS ARTICA DELUXE"in the Bluetooth device
list.
4. According to indication, enter password or PIN No:"0000",and press the key of"
Yes" or "confirm.
5. After successful pairing, select "NGS ARTICA DELUXE" in the Bluetooth device
list, and press "connect".
6. After successful connecting, the blue LED of the headset quickly blinks twice
or three times every 4 seconds.
3
Remarks:
• If pairing is failed, please turn off the headset first and then re-pair according to steps 1-6
LED indicator
• After pairing is successful, the headset and the cell phone will remember each other, they
Blue LED is on for 1 second
Red LED is on for 1 second
• Every time the headset is turned on, it will connect to last connected device automatically.
3 Making calls with the headset
LED indicator
Función
Red and blue LEDs blink
alternately. Cancel calling
Answer a call
Reject a call
End a call
Volume up
Volume down
Transfer conversation to
mobile phone
Transfer conversation to
headset
Microphone mute
Cancel mute
Voice dial
Redial the last number
Remove paired list
mentioned above.
will no need to re-pair next time. The headset can remember 8 paired devices, when the
number of paired devices exceeds 8, the first one will be replaced.
If you want to pair it with other devices, please turn off the Bluetooth function of last
connected devices first and pair the headset with the new device according to steps 1-6
mentioned above.
Basic operation
Estado de los auriculares
Calling
Incoming ringing
Incoming ringing
During a call
During a call
During a call
During a call
During a call
During a call
During a call(micro mute)
Standby mode(have already
connected device)
Standby mode(have already
connected device)
Turned off
Funcionamiento
Short press MFB once
Short press MFB once
Long press MFB for 2 seconds and
release it until listen a tone
Short press MFB once
Short press button
Short pres button
Long press MFB for 2 seconds
Long press MFB for 2 seconds
Double click MFB
Double click MFB
Long press button for 2 seconds
Double click MFB
Press MFB and pause button for 8
seconds simultaneously, and release
it until the red and blue(or purple) LED
on at the same time