Magneto Assembly; Starter Motor; Regulator/Rectifier - Arctic Cat Y-6 2006 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
2. Connect the red tester lead to the blue/yellow
wire; then connect the black tester lead to the
green wire.
3. With the switch in the OFF position, the meter
must read an open circuit.
4. With the switch in the RUN position, the meter
must read less than 1 ohm.
NOTE: If the meter reads more than 1 ohm of
resistance, troubleshoot
switch/component, the connector, or the switch
wiring harness.

Magneto Assembly

REMOVING
1. Disconnect the battery.
! CAUTION
Always disconnect the negative battery cable from
the battery first; then disconnect the positive cable.
2. Remove the flywheel from the engine (see Sec-
tion 3).
3. Remove the stator and timing sensor from the
stator plate.
KEY
1. Flange Bolt
2. Cooling Fan
3. Flange Nut
4. Flywheel
INSPECTING
1. Check stator for signs of overheating, broken
wires, or other damage.
www.mymowerparts.com
Back
5-6
or replace the
5. Flange Bolt
6. Bolt
7. Stator
740-502A
Back to TOC
2. Check the timing sensor for broken wires or
signs of damage.
INSTALLING
1. Install the timing sensor and stator onto the sta-
tor plate. Secure with cap screws lightly coated
with red Loctite #271. Tighten securely.
2. Install the flywheel (see Section 3).

Starter Motor

NOTE: The starter motor is not a serviceable
component. If the motor is defective, it must be
replaced.
REMOVING
1. Disconnect the battery.
! CAUTION
Always disconnect the negative battery cable from
the battery first; then disconnect the positive cable.
2. Remove the starter motor from the engine (see
Section 3).
3. Remove the nut securing the positive cable to
the starter; then remove the cable from the
starter. Account for an O-ring.
INSTALLING
Install the starter motor (see Section 3).

Regulator/Rectifier

The regulator/rectifier is located near the battery.
VOLTAGE
1. Set the meter selector to the DC Voltage posi-
tion.
2. Test between the black and white wires (with the
regulator/rectifier plugged in).
Back to Section TOC
Next